Prusa Mini Mosquito Hotend Mount

  Remix of Mosquito Hotend mount for the Prusa Mini + from CrisPersi.  Adds the use of the stock Bowden tube fitting and Super PINDA bracket.  No change in Bowden tube length or nozzle position compared to stock. Uses a 13-13.2mm Teflon tube and the following additional fasteners:

2 X M2.5 X 16mm Flat Head Cap Screws

2 X M3 X 14mm Socket Head Cap Screws

1 X M3 X 6mm Socket Head Cap Screw

5 X M3 Heat Inserts (~4mm OD x ~4mm OAL)

  Added a version for an M6 Bowden tube fitting.  It uses the 2 long M2.5 SHCS that come with the hotend instead of the M2.5X16 FHSCs.  Teflon tube is 9.0-9.2mm for this version.  Everything else is the same as above.

  Added two 25mm fan versions with a simplified squared off shape for both M6 & M8 fittings. Created a small optional air guide that fits behind the 25mm fan to reduce air leaks towards the print surface. 25mm 3 wire fan: https://www.mouser.com/ProductDetail/CUI-Devices/CFM-2507CF-0100-240-20?qs=ulEaXIWI0c84q0hprd89xA%3D%3D

Added versions with Slice Engineering Logos.  Thanks 10prongato for the suggestion and the help getting approval from Slice.

Slice Engineering is a registered trademark of Slice Engineering, LLC
Trademark used with permission from Slice Engineering, LLC

  You will want to test your PID values after this upgrade.  Here's the PID values I added to my start G-code to get you started:

M301 P19.41 I1.44 D65.61

  If you would like to increase part cooling, I recommend upgrading the stock fan to the 7.38 CFM LDO fan sold by Printed Solid & Filastruder.  So much more air and no need to swap out the X-Carriage for a new duct!  The change to this fan really woke up my part cooling system and highlighted how well the stock Mini+ parts cooling duct was designed. The fan is a direct bolt-on, runs 0 to 100% speed without causing any errors but is noisier than the stock fan.   I have found no airflow issues with or without the Slice Eng Boot installed. 

Links=>

 https://www.filastruder.com/products/ldo-5015-5v-blower-fan-df5015h05s

or

https://www.printedsolid.com/products/ldo-5015-5v-blower-fan-df5015h05s

Video of my 22 minute Benchy with Input Shaping Enabled:

G-Code file is attached as a zip file: (Printables did not like the M301 line)

The 22minute Benchy 3MF file is attached as well

30 minute Benchy without Input Shaping:

Added a new video: 22minute Speed Benchy using 5.1.0Alpha1 firmware.