MKS LCD Case bracket for 18mm board

MKS LCD case bracket meant for this case design: https://www.thingiverse.com/thing:1974974. I printed the case then didn't have any mount so the lcd was just loose so designed this bracket.

It will also work with this: https://www.thingiverse.com/thing:1922863

It clamps top and bottom to a 18mm board, the gap is actually 19mm to give a bit of wiggle room which works perfectly.

Update:

I realised that at knee height the original design is likely to get ripped off the board when I inevitably knock it so redesigned it so it isn't sticking out from the board. I've left the old one in there so you can choose if you want the risk of knocking it :)

Update 2:

Still wasn't happy so added a new design with the display sitting further back.