Printed the 19cm on eSun PLA+, Cura Standard 30%, and it came out well. I had a couple of stringers between the outer/inner sections and had to force some material through a few times to clear, but that's more of a printer setting/performance issue than a design flaw. Sorry I don't have a pic, but works well! Thanks for submitting!
Printed the 19cm on eSun PLA+, Cura Standard 30%, and it came out well. I had a couple of stringers between the outer/inner sections and had to force some material through a few times to clear, but that's more of a printer setting/performance issue than a design flaw. Sorry I don't have a pic, but works well! Thanks for submitting!
@muztan_386690 Thank you so much for your feedback! Hope you can use it and it will make a lot of your work easier!