Redcat Racing Volcano Epx Rc truck gopro mount

This mounts over the rear 2 body posts under the pins and over the body. I made this because I didn't want to put a permanent adhesive mount on the truck. It is for a Redcat Racing Volcano EPX but would probably work on almost any 1/10 scale rc vehicle https://www.amazon.com/Redcat-Racing-Electric-Volcano-Included/dp/B00HVBVNVG/ref=sr_1_3?ie=UTF8&qid=1514388781&sr=8-3&keywords=volcano+epx

I used the clip mount here: https://www.thingiverse.com/thing:539135

Update- The design has been modified to fit the truck much better. The old design was pretty bad as I threw it together fast on Tinkercad.

Print Settings

Printer:

Qidi Tech X- One 2

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

Doesn't Matter

Infill:

Doesn't Matter

Notes:

I did not use supports as my printer is fairly good at overhangs. If your printer struggles with overhangs then use support.

Modifications

I superglued some foam to the bottom to make it super tight to the body to minimize vibration. I will be testing on the beach soon so videos with the mount are coming