Ender 3 + SKR v1.3 - mounting plate

SImple mounting plate to mount SKR v1.3 board in Ender 3. All hardware of ender 3 remains the same.

Mounting

As board sits sideways, there is no way to access USB port and SD card. SD card is accessible after opening the top case and it can be replaced without doing anything more.

For USB connection (Octoprint or anything similar), I cut and soldered broken USB cable to the bottom side of SKR board (USB pins are marked there) and put it outside to where my Raspberry PI is.

I also recommend routing all motor/end-stop and display cables under the mounting plate to make it tidy and easier...