Raspberry Pi Enclosure - Case for a Pi, Battery, Charge/Boost Board , WiFi, Fm Transmitter with External Antenna and whatever else can be crammed into it much like the Marx Brother's cabin in A Night At The Opera

• Based off of http://www.thingiverse.com/thing:238154
• Covers up the large openings on the side
• Adds a system for simple mounting options
• Opening for cables/charging and an external FM antenna, Both the opening for the antenna and the cables can be closed off with calking or the like.
• Plenty of room for sensors, speaker, mic, etc etc etc One of the pictures above shows V.02 stuffed with a RasPi B+, Adafruit's Powerboost 500C, LIIon 3.7V 4400mAh Battery. USB RTL2832 w/R820T, USB WiFi (802.11b/g/n) Module with Antenna and an Adafruit Stereo FM Transmitter with RDS/RBDS Breakout - Si4713....not fully assembled..nor tested...ymmv.

Use Case :

• LibraryBox with Battery
• FM Transmitter
• SDR Master
• All of the above

Change Log :

• V .03 Made the top 1% larger to see if it will close better
• V .02 Added hole for charging cable option
• V .01 Moded original model to include mounting options and to fill in the sides.

Inspiration :

Instructions

Print with supports on. I am futzing with getting the top and base to print on a small bed with as little supports as possible. Also, the two halves sort of almost close. My prints have been a wee tight and thus I am making the top about 1% or 2% to see if that helps.