Ultimaker 2/2+ BLTouch Mount

This model replaces the bottom plastic section of an Ultimaker 2/2+ Printhead.
It also features routing holes on the sides for easy side fan wire routing and a channel behind the BLTouch mounting point to safely route the BLTouch cables.

Special Notes:

As long as your screws do not stick out the top of the BLTouch mounting location, it should slide cleanly under your front drive belts without issues.

If you find the Z offset is too far, use washers between the BLTouch and the mount to lower the position of the BLTouch

Printing Instructions:
Support will be needed.

Print in PETG / Nylon / ABS 
You could optionally print this in resin.