Death Star Wall Panel (Photography)

I wanted to design a few backgrounds that could be backlit for small model photography.  After printing, you can back with a filter material or paper.  I ended up using white index cards.  The stands should be press fit, but may require a dab of glue depending on your printer.

Models - Descriptions

• Empire_Wall_Panel-168mm - 168mm wide panel.
• Empire_Wall_Panel_84mm - 84mm wide panel.

Stands

• Empire_Wall_Stand_168mm - Full length wall stand (Reduce length 24mm if doing a corner, or reduce length to 84mm if doing the 84mm wall).
• Empire_Wall_Stand_Corner - 24mm Corner for use when joining two walls at 90°

My Print Settings:  

• 4 perimeters
• Models should be printed face down (default of downloaded .stl)
• 0.20mm Layer height

Original Redesign/Remix from this panel:  https://www.thingiverse.com/thing:2537299