Plastic Model Runner Stand

Tired of my gunpla runners tipping over on a light and flimsy stand. Made one of my own with a heavy base and some lean.

15 slots, with 10mm gaps. Will fit most HG kits, unless it is a nightingale/ xi. Will probably need 2/3 bases for RG and MG kits.
Could have more slots but I don't have an XL/ large format printer.

Recommended print settings:

[Base]
0.3mm layer height, 2 walls, 10% gyroid infill, brim 3mm.
*It will take the whole MK3 print bed, some adjustments required. (sorry Mini users)
[Shoulder]
0.2mm or lower layer height, 2 walls, 10% gyroid infill, support from base.

**This print uses quite a bit of filament (200-300g), print at your own wallet/ or if looks doesn't matter, just use trash/ leftover filament.

Have fun watching the first layer. ;)