TC15 light filter/diffuser

Needed a red filter for my TC15. This is thinner at the front than the walls, so more light will be directed forwards. Works as a decent diffuser, but won't have as good a distribution as a conical design..

DO NOT USE TURBO OR HIGH MODE. Turbo softens the front in seconds, and eventually starts smoking. High mode gets quite hot as well. The lower settings work fine, just monitor temps.

Printed in red PETG, 4 walls and 100% infill. Tight fit, soften sides with a heat gun or turbo mode if you need to make it looser. PLA should work, just might not handle the heat output as well.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Filament: Amazon PETG Red