Tray tilted 45° for IKEA SKADIS

Trays for SKADIS to store miscellaneous items.

It is approximately 198 mm wide, 112 mm high, and 116 mm deep.

Up to three dividers can be used at the same time.

My print settings are 3 perimeter, 20% infill, and 0.3mm for layers.
No support is needed when oriented face down.

Depending on the filament material, warping may occur, but it does not affect the functional aspect, so brims and rafts are not necessary.

Since it is tilted at a 45 degree angle, be careful not to use too long, too heavy, sharp, or leaky.

Drilling holes to save resources. Design is secondary:)