This is a remix of the Doom Keycard.
It allows you to slot in an ID card (In case you have to show photo-ID at your place of work).
I printed a front panel from JohnnyDarling's design and used this as the back panel, no mid piece required.
Print with supports on buildplate only. Then you wont need to pop supports out of the gap.
I also set my infill to 50% to give the retaining posts some chance of not breaking when removing the supports.
This is probably hideously designed but I am a n00b.
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
50%
Filament: Any PLA Any
Notes:
Supports on build plate only!
In theory infill would be even better at higher % for the retaining posts, but then you are wasting filament on the outer edges.
Tried my best
Throw things into Tinkercad and mess with it until it looks ok.
Category: Video GamesThe author marked this model as their own original creation. Imported from Thingiverse.