A grid or honeycomb can be fitted over a light source to help control the spill of the light it produces. They look like bees' honeycomb (hence being known as honeycomb grids) and are great for helping to make a beam of light that is soft but focused.
Light Modifier - Fits the Neewer RGB61 and ULANZI VL49 RGB Photo/Video Lights.
PRINT INSTRUCTIONS:
- Print with supports for the entire bottom build plate.
- Must Use A PrusaSlicer Modifier. (Included Photos shows PrusaSlicer settings). Pay close attention to the modifier box and its position in my photo.
- Right click model name in right settings pane (Refer to Photo).
- Select Add Modifier
- Choose Box
- Size and place box through the center of the model (Refer to Photo).
- Right Click the box you created and select
- Density: 13%
- Pattern: Honeycomb
- Right Click the box you created and select Layers and Perimeters.
- Bottom Layers: 0
- Top Layers: 0
- Rotate model to 45 degrees.
- Print with supports for the entire bottom (cut out, inside lip and bottom center).
- Slice and check to be sure you can see through your Honeycomb Grid down to supports.
Tags
The author marked this model as their own original creation.