I lovePLINKs, been using them for years. But they're so hard to manage, they either stick in the case they come in, or all jump out and try to escape. If you've got the same little annoyance, print up the dispenser. Needs no rafts, supports, nor anything special. You can stick it on the back of your under-sink door or anywhere convenient. It has countersunk holes for screws, or just use double-stick tape.
All about Plink; https://summitbrands.com/plink/garbage-disposal-freshener-cleaner-assorted
All about Arm & Hammer; https://armandhammercleans.com/garbage-disposal-cleaner
Also, I'm testing - and welcome your feedback; https://www.ebay.com/itm/114954754410
Sorry about the light grey text. :-\ NOTE TO THINGIVERSE: If anybody sees this;
Enjoy!
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
0.20mm
Filament:
Generic PLA Category: Kitchen & DiningThe author marked this model as their own original creation. Imported from Thingiverse.