This is a mount for the pimoroni trackball to go on a kyria keyboard. The 3 similar designs (not the "original") would probably fit in any case, but the original is pretty specific to the case found here, which can also be seen in the pictures. I also took the kyria logo for one of the designs from that case.
This will require a few M2 screws to attach the trackball to the mount and the mount to the keyboard. with one of the 3 similar newer designs, mine used two M2x4mm screws for the trackball->mount, and one M2x8mm for the mount->keyboard.
Printer:
Sunlu S8
Rafts:
No
Supports:
Doesn't Matter
Resolution:
2
Infill:
20
Filament:
Sunlu PETGWhite
Notes:
I printed it with supports, but it should work either way. It's a fairly short bridge to get across on the bottom of the wire shield.
This took me about 15 minutes to print at 50 mm/s. Category: ElectronicsThe author marked this model as their own original creation. Imported from Thingiverse.