This is rest designed specifically to go on this case:
https://www.thingiverse.com/thing:4857192
It would also work on this case without the tenting:
https://www.thingiverse.com/thing:4378710
The M5 screw through the bottom isn't entirely necessary, but I added it just for a little extra stability. The side resting on the desk and the hooks keep it pretty sturdy. The screw I used was an M5 30mm, but that depends entirely on the angle of the tenting.
To print the right side, just mirror the object in a slicer or cad program.
Printer:
Sunlu S8
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
5%
Filament:
Sunlu PETGWhite
Notes:
Tweezers or something will be required to get the supports out of the hole for the screw. the other supports come off easily as long as a sufficient z-gap is set.
these each took me about 4 hours printing at 75mm/s, with first layer at 20mm/s. Category: ElectronicsThe author marked this model as their own original creation. Imported from Thingiverse.