Pulley Light

Industrial look Pulley light

For the weight you will need a 6mm threaded rod cut to length along with two self locking 6mm nuts. Along with large washers, I think I used 45mm diameter ones as weight, worked out nicely.

A bit over kill but I used two bearing inserted into each pully. 5x10x4 for large pully and 3x8x4 for smaller pulley, these are a push fit.

The cable is a 5mm diameter type.

• Be careful and make sure weight is correct, and the threaded rod isn't sticking up impeding the cable before glueing. Once super glued the cover isnt coming off again.

Print Settings

Supports:

Yes

Resolution:

0.2 - 0.3

Infill:

20

Filament:

Pearl Mouse, PLA Extrafill Pearl Ruby Red

Notes:

Print puleys standing up right with supports