Aperture Science Coaster

Looks great and works fine so far!

Printed in PLA, scaled to 128.58 % (diameter 9 cm), so I can put tea cups on it. The inserts were a little bit smaller than the holes in base, but maybe I just messed up the scaling between base and the inserts, while slicing it. Anyway, it was not a big deal, I have glued them to base and it holds fine.

Filament: EKO MB recycled PLA (White + Black)

PS: I haven't tried to put hot tea on it (only cooled down), so hopefully it won't melt :-)

Pretty, prints well. Scaled to 125% in length and width. Only downside is that the inserts are not identical, but now I see that someone already remixed it
EDIT: I used PLA, does not melt (edited)