I wanted to use the design from another here: https://www.thingiverse.com/thing:2076034.
But I had to be protective of the table surface so needed to fit rubber protection.
In the end i redid drawing from scratch in fusion 360.
You can purchase rubber feet at any hardware store 38mm in diameter or less.
I gave ample clearance of the m18x2.5 thread so no need to print in different sizes.
No need for any supports. But for strength i would suggest using 4 perimeters and around 25% infill.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: PolyMaker PLA
Category: OfficeThe author marked this model as their own original creation. Imported from Thingiverse.