I was installing some lighting in my garage and used 25mm x 16mm rectangular conduit to neatly manage the wiring. Unfortunately there are no corner connectors or covers available to buy from my local hardware store. I finished my install the hard way by cutting 45 degree mitres in the conduit when I needed to change direction but this was a real pain.
So I decided to make some corner covers which might save someone else the hassle.
This cover is made specifically for 25mm x 16mm rectangular conduit. The funny thing is that there are differences in the conduit even though labelled 25mm x 16mm. I have examples that are 25mm x 17mm even though labelled 25mm x 16mm (my excuse for lousy mitre cuts). This cover allows for both.
Cheers
John
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20
Filament: eSun PLA+ 1.75mm White
Notes:
Temperatures:
Bed: 60 degrees C
Hot End: 215 degrees C
Adhesion:
Printed on mirror using glue stick
Category: DIYThe author marked this model as their own original creation. Imported from Thingiverse.