Ender 3 Max Bottom brace motor side

One more Z brace for Ender 3 Max.

This time for motor side of extrusion profile.

This brace is designed with motor support in mind so it does not hang in the air pulling everything down.

It is adjustable vertically for a few mm. 

Since i have modified my Max for dual z, my motors sit higher, but the model is adjusted for stock single Z.

In case you need it, there is a model of shim you can easily cut to desired height or merge with main model with slic3r depending on the setup.

• M4 T-Nut and a screws needed for installing
• Print the open side down on heatbed, so the brace has more uniform strenght.
• 6 walls/top/bottom layers
• Expansion already acounted for in designe.
• Mirror the model for opposite side.
• Depending on how good your printer corners, you may/or may not need to do a little sanding on the edges to make it super flat. 

Additional MAX mods

Zaxis top braces ZBraces

Front side Z Brace in models here