Behringer XENYX 302USB Stand
Description
PDFFor the longest time, I've had my input mixer leaning up against some small boxes. Then I printed the stand here https://www.thingiverse.com/thing:2038119 However I didn't have a good matching set of hardware to fit snuggly against the frame. So I decided to model a version which fits into the side clips!
It provides enough stability without needing the screws on the back, and doesn't require any additional hardware. Just a standard Philips head screwdriver is needed to remove the screws.
The fit is decently tight, since I modelled it with 0.2mm clearance. Definitely make sure your print bed is properly levelled and doesn't produce too much of an elephants foot.
I've been learning how to use Fusion360 and have made a lot of other models, but this is the first one I've decided to share since I know a lot of people could benefit from this.
Let me know what you think!
Print Settings
Printer:
JGAURORA A5
Rafts:
No
Supports:
No
Resolution:
0.3 was what I printed in, but 0.2 would be ideal
Infill:
25%
Filament:
Prusament PETGOrange
Notes:
Print the item flat on its face, you shouldn't need to use any support matieral at all if orientated correctly. It should be plenty strong, especially since I thickened the inside edge with a champfer.
Any standard material should work fine. However I haven't accomodated for ABS shrinkage, so maybe adjust that if needed in your slicer.I would personally reccomend PLA or PETG
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.