Thank you very much for the contribution. I was looking for a 3way module for the tower that fits on the Mini without cutting and glueing. Here we go
3-Way Planting Module for Hydroponic Tower
This is a one sided 3-way planting module for more plants at the sunny side.
In the contest Plant Pots
130
478
2
5816
updated
April 26, 2023
Makes
Comments
i printed this model at 75% this enables me to have a few plants indoor through the winter. i also used a 2inch cup at 75% to fit
Are there any other parts that fit this tower piece? A base and cap perhaps? I looked at the link you sent but it doesn't look the same.
@NoBS_808418 I know on some pictures it seems like it is a different tower but I checked it again and it´s still the same model that I used. Notice, that there are often 3 different versions of a X-way-planting-module (with and without M3 and hollow). The filling-module usually is the lowes module. Below that, there only is one of the adapters. It depends on your water reservoir which adapter to use. There is no reservoir to print, you have to buy it. Hope this helps you ;)
Good morning A black tower does not heat the water too much ?
@civodul62_432121 Hi! Depending on the amount of direct sunlight, black material might get a little too warm. White material on the other hand might lead to alga growth. Therefore I mainly choose grey material and some bright coloured parts to attract bees.
@w3rN42 salut ok merci bien :)