Xbox Elite Controller Gen 2 Stand

I have a small desk and the case that the gen 2 elite controller comes in is very bulky on my desk. So I wanted to have something smaller and something that would look better. I saw jupitas design and put my own twist on it. I did not edit his design and had taken my own measurements but the general idea for the design is based off theirs. Feel free to offer suggestions or improvements. There is also holes in the bottom for 3mm rubber feet to stop the stand from sliding.*(I have added the AC in the top right to my personal stand I have removed that from the STL file shared on here)* Amazon Rubber feet I used: https://www.amazon.com/gp/product/B06XCNM69B/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

Print Settings

Printer Brand:

Ultimaker

Printer:

S5

Rafts:

Doesn't Matter

Supports:

No

Infill:

20%

Filament:

Notes:

0.15 mm layer height

This is an earlier prototype but wanted to show that the charger does fit and the controller does charge on the stand.