Plant Pot on Stilts

A nice plant pot on stilts with a watercatcher
In the contest Plant Pots
12
23
0
198
updated November 4, 2022

Description

PDF

A plant pot on 3 stilts. The pot itself has a small hole at the bottom end to drain water. The base has a small hole in the middle to catch the water and conduct the water in 3 directions in the pool. 15% infill for the base should be good enough.

Instead off the printed poles you can use metal also if you have but its not a must have. The poles have a diameter of 6mm and a length of 200mm. Put the seam of the pot behind a stilt so you have a clean surface. Just print walllines 0.2 and no infill for the pot.

The poles should be printed with 3 walllines and minimum 20% infill.

Enjoy

Model origin

The author marked this model as their own original creation.

License