Peak Design Mobile Continuity Camera Mount for Apple Studio Display

A magnetic mount to adapt Peak Design's Mobile Case to an Apple Studio Display for use with Reincubate Camo or macOS Ventura's forthcoming Continuity Camera feature.

Requires 4x 10mm x 3mm refrigerator magnets and a suitable pause at the appropriate layer to embed them in the print.

I recommend you use Peak Design's Mobile case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction. This should also be compatible with MagSafe natively without a Peak Design case if you remove the boss from the center of the mount, but I haven't tested it.

My first print so far (GCODE available here) with this design was with:
- Prusament PLA Galaxy Silver
- 0.15mm layers, QUALITY preset in Prusa Slicer
- 4 perimeters
- 15% gyroid infill
- supports only on the Studio Display clamp/rail
- printed with the broadest flat side (faces you on the mount) down on the plate