Tango 2 Travel + Gimbal Protection

I wasn't thrilled with any of the designs I was seeing and needed something a little more robust in order to feel comfortable putting this in a pack while hiking or off road. Had quite a few iterations on sub-parts and I'm happy with this latest full rev.

• This has a 12mm openning to allow for my lotus ends, but it grips primarily (still intentionally loose) at the bottom. So should work with stock ends without need for modification
• It works without the body brace. Just as good as other designs on TV.
• Recommend to print in TPU. PLA might be to rigid to allow snap fits and getting around gimbals
• To easily remove just slide the throttle gimbal up, pop off top hook near antenna, and pull back while sliding out from under throttle gimbal.

***Don't be cheap like me. Just get the Tango 2 Pro with folding gimbals. In hindsight I wish I would have. But I will would have designed something like this for those off-road trips.

Print Settings

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: SainSmart TPU