VORON Design Calibration Cube Stand

This is a modular stand for your VORON Design calibration cubes.

The stand can be expanded horizontally and/or vertically using the "mending plates" and M3 screws (I used M3 hex socket button head cap screws). Typically I used M3x12mm or M3x14mm for the screws that go into the base plates and no longer than M3x8mm screws that go into the top of the backs to connect the next level above. There are also small clips that can be used to keep the base plates straight and not separate at the front. The clips come in large and small sizes although printing in PLA the small size typically works best. The large is provided for a slightly tighter fit.

There are two versions of the "tray" pieces. The only difference being the way the VORON Design logo is set in the tray.

There are additional test print stands available.

If you print a Filament Friday CHEP cube or any 20mm calibration cube: 20mm Cube Stand 

If you print CreativeTools jolly 3DBenchy at the original size: Sea Port Benchy 

If you print MatterHackers Phil A Ment at 50% of the original size: Moon Base Alpha 

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

15%

Filament: Hatchbox PLA

Category: 3D Printing Tests