The Planter Pot

Bring the outside inside with this cute plant pot modeled on an outdoor wooden planter. This was designed as an entry for the plant pot competition.

I printed with Sunlu wooden PLA filament, 0.3mm layer height with a 0.6mm nozzle. The pictures are printed at 50% scale (~80 mm) as I was running low on my wood filament.

The trim is not necessary but does add a nice finishing touch, just attach them on the top using your preferred adhesive. If adding, make sure to print 4 of them.

The vase mode liner is just because wood filament doesn't stand up super well to the soil and moisture, so you can print in PETG or more resistant PLA if you like. It fits snuggly inside and sits up on top of the small bumps to allow for some drainage from the soil.