Ultimaker 2 camera holder v2

A mount for Logitech C270 webcam with its stand taken off. Very likely to work with other similar Logitech cameras with same stand design. Hangs in front of Ultimaker and angle of the camera can be adjusted.

I attached the camera to the mount with two M3 8mm screws. You can also use a M2.5*20mm bolt and a M2.5 nut. Mount and balancer can be joined by glueing them together. Or with acetone if ABS is used for printing.

This is an improved, more simple design over the original Ultimaker 2 webcam mount.