Coffee Pad Holder Holder (Senseo)

This is a holder for coffee pad holders (Senseo) for mounting on the wall. A drain is built in, so that any coffee residues are collected in the reservoir at the bottom.
The holder is attached to the wall with two clips so that it can be easily removed for cleaning.
The clips are simply attached to the wall with double-sided adhesive tape.
I was inspired by the following pad holder: https://www.thingiverse.com/thing:251074

Print instructions

Rafts: Yes

Supports: Yes

Resolution: 0,25

Infill: 20%

Notes:

Print the holder with raft (better adhesion because it is small and high) and 20% infill as well as 0.25mm layer height and supports.
For the clips you don't need a raft but take a bit more infill (40%) and a layer height of 0.2mm.