Spiderbeam 12m Mast - HAM RADIO

short : 

Important notice:

If you choose to buy it — thank you so much!

https://cults3d.com/en/3d-model/gadget/spiderbeam-12m-mast-ham-radio
Your support means a lot. 

By purchasing this model, you are authorized to:
✅ Print, copy, and distribute 3D prints of this model
✅ Use the prints for any purpose, including commercial use
✅ Produce and sell unlimited quantities of physical prints

🔒 Note: This license applies to physical prints only. Redistribution of the digital 3D model file itself is not permitted.

Happy printing — and thanks again!

Before you begin, please use a calliper to measure the diameter of your Spiderbeam pole. The Ground Plate inside hole diameter 66mm to allow for a snug fit with the rubber cap. The Guy Plate's inside hole diameter 55mm to enable sliding and stopping in the specific position, as shown in the photo.

If the dimensions of your 12m pole are different, you may need slight adjustments. If you have different Spiderbeam poles and your setup varies, I can assist you as long as I have the necessary files.

Please get in touch with me, specifying the model and brand for which you intend to use this system. Also, provide the Ground Plate (adding a few millimetres for tolerance) and Guy Plate inside hole dimensions. I can then make these specifications available to everyone and assist you in creating an updated model.

If you're interested in additional items like the ones I used in the photo, you can find them in these links. Special thanks to @SaddamCZ for their contributions:

Beefy Tri-Lobe Tent Stake Cap

https://www.printables.com/model/35604-beefy-tri-lobe-tent-stake-cap

Guyline cord tensioner hook

https://www.printables.com/model/39883-guyline-cord-tensioner-hook

Important notice:

This design is free for the benefit of the community, but If you like my designs and want to contribute, you can make a donation to paypal, that will be greatly appreciated.