I was annoyed with cleaning up coffee grounds one to many times after I spilled them all over the place. Then I wondered where I could best put it before I pour the water. Now there is a solution!
This will fit onto any moka pot with a 3mm diameter screw on top. My screw sticks out of the pot about 7mm and the grounds basket is about 11.8mm. You may be able to print it as is, but best to check if you need to change one of these measurements.
Printed with PLA, not the best when it comes to heat, but holds up just fine as it doesn't get much abuse when its warm. Best to print with PETG if you have it.
The author hasn't provided the model origin yet.