Z42 Prusa Mini Display Holder with power switch relocation

Prusa Mini power switch relocation to the back of the Display holder. Remixed from the R2 version of the Prusa files.
7h 57m
2× print file
0.20 mm
0.40 mm
81.00 g
16
45
0
569
updated June 13, 2022

Description

PDF

I wanted a more convenient way to switch the Prusa Mini on/off so this remix of the display holder to accommodate the the original power switch at an angle on the back. It also covers the top of the display control board to prevent touches when switching the machine on/off.  

To change the switch location you will need to extend the switch wires from the control board.  I ran them through the hole that the swtich was in and covered the wires with some wire wrap.  Be sure to do this in a safe manner.

Included are two version, one with Prusa across the top and one without in both 3mf and Gcode format with necessary supports and support blockers in place.

The two Gcodes are .2 layer height for PETG.  

It can be printed in PLA, be sure to use the 3MF and make the appropriate filament settings changes.

Tags



Model origin

The author remixed this model.

License