Minion Stuart Multi Color

*** update 24 Jan: asked on feedback uploaded a version 2 of the skull that has a little wider opening for the hair. Should make it a little easier to assemble.

Third in a series! If you like this, please scroll up and hit that like button. It helps get exposure. Check out the others in a link below. Follow me for future uploads.

Minion Stuart!

As I have said before, the great work of RedDadSteve inspired this collection. Check him out!

Bob: https://www.thingiverse.com/thing:4722509

Kevin: https://www.thingiverse.com/thing:4713479

RedDadSteve: https://www.thingiverse.com/reddadsteve/designs

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

No

Supports:

No

Resolution:

0.12

Infill:

Various

Filament: Hatchbox and eSun PLA Multiple

Notes:

Print as arranged here. I did the work to have them properly on the bed for you.

The goggle and the band have a “T” engraved on them. That goes towards the top.

The skull, goggles, band and neck go together in a specific order because of the curvature of the skull

Carefully test fit the band and goggle.

Carefully test fit key into this assembly and disassemble.

Test fit key into neck and skull holes and disassemble

You may need a little sanding of the key if any of the parts have any elephant foot.

Line up goggle with skull so the key hole fits. Make sure the T goes towards the skull

Insert key

Place band over key and goggle.

Place this assembly on neck

Hair is a challenge. Make sure you clean up the bottom of each piece ONE AT A TIME and keep track of them as they are on the board. They print facing front.

****** support recommended for the mouth opening in neck

****** brim recommended for hair

Post-Printing

Clean up any elephant foot and carefully test fit.