Pt Arrowood Light

** Update 5/17 - i had a typo in the instructions - the M5 Bolts needed are M5x12, not m5x8. Sorry about that

• Update 5/13 - links were broken in instructions. Fixed

A Lighthouse design from my own mind. No real lighthouse exists!

This has a rotating LED light.

It can be printed without the electronics

Moderate level work in the Single Board Computer Parts. It uses an Arduino Nano, a Stepper Motor and a 7 LED NeoPixel Jewel. Instructions included. If you are new to SBCs - do that part first.

The toughest assembly part is getting the window rails lined up into the roof. Be careful.

The finial and entry roof are the only glued parts. All the rest are friction fit.

Assemble the railing, Railing top, Lamp House, Roof, finial and locking ring together as one assembly. Once the rest is put together, carefully lower it over the lamp and let is rest onto the three pillars of the stepper bracket. It is a tight fit over the lamp but it fits.

The Arduino Sketch and the instructions are in the .zip folder

Can be printed on a bed as small as 200MM x 200MM

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

No

Supports:

No

Resolution:

various

Infill:

10

Filament: Various PLA Various

Notes:

I uses a 0.8MM nozzle at 0.24MM layers for most of the model.
My tower is [Hatchbox](https://www.amazon.com/s?k=hatchbox&linkCode=ll2&tag=thingiverse09-20&linkId=f798b0df863f056fa470f03a65697ff4&language=en_US&ref_=as_li_ss_tl) Magic Stone Brick and Marble,

The railing is Polymaker Polyterra Cotton White

The house is Esun Black

The Roofs are Esun Pine Green

The finial and Lamp are Hatchbox Tue Gold