Mellow NF Sunrise - Fan Mount and Duct for 4010 / 4020 Blower

Now supports stock 4010 Blower and 4020 Blower Fans

This is a mount and cooling fan for the Mellow NF Sunrise HF 12V Volcano Hotend Direct Drive Extruder for Creality CR-10 or equivalent printer.

Note, only the mount and fan duct was designed by me.

Use existing blower fan and screws for assembly.

3 x M3 screws (Mount plate)

4 x M2 screws (Stock Blower)

Assembly:

Screw 3 M3 screws to fasten the mount to the extruder body.

Screw the top two long M2 screws in to fasten the stock blower fan.

Screw the bottom two short M2 screws in to fasten the fan duct to the stock blower and mount.

The step files included for measurement references were not made by me, here is a list of the references.

Mellow NF Step https://www.thingiverse.com/thing:4894277

Adjustable BL-Touch Mount https://www.thingiverse.com/thing:3148733

BL-Touch Model https://grabcad.com/library/bltouch-v3-1-2

CR-10 Parts Reference https://github.com/Creality3DPrinting/CR-10

Volcano Heat Block https://grabcad.com/library/volcano-heater-block-1

Category: 3D Printer Parts