E3D Hemera - Fan Duct Remix - Fan Duct with 18mm Probe Mount

First off thank you so much to Print-3D for creating this model. The original works very well and the cooling performance was amazing on my 3D prints, so thank you. 

The reasons I remixed this model was because I have a EZABL Pro 18mm on my CR-10 V3 which is a Frankenstein Printer at this point in the game with all the mods i have done to it. I have added the probe mount to it which sits directly in front of the nozzle by 44mm to center(this is you offset to input in you firmware). there is no left or right offset.

with the original fan duct mounted in ABS  I noticed that when I printed in ABS with it, it started to warp the fan duct a bit. So I re-designed the fan duct to be further back from the heater block while still pointing the air flow to the print. once i did an ABS test print with it on, I got no sags or warping issues due to the further distance away from the heater block. i also tried it with PLA with amazing results. 

Please from this from ABS or PETG, as PLA will maybe deform over time possibly. (i have not tested it out yet). Supports are needed to support the EZABL probe mount and where the mounting screws will be inserted to the Hemera. Print it at 0.16mm layer heights, 20% infill, and 3 perimeters. 

I have included the stl. and step. and GCODE file I used to print this model, in case you wish to use it.

Hope you all enjoy this remix.