The original mix of the seaduck cowl had to be printed nose side up to get a good print out of it. That required A LOT of support.
I sliced the cowl nose off so that it could be printed in two pieces: nose ring with nose up, and rest of cowl nose down. this eliminates the need for support completely.
I included a couple of alignment pins to help aligning the nose and cowl for gluing.
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
No
Resolution:
0.08
Infill:
10
Filament: eSu PLA Red
Category: R/C VehiclesThe author marked this model as their own original creation. Imported from Thingiverse.