Ubiquiti Switch Flex Mini wall mount

I wanted to create a simple clip-type wall mount for my Ubiquiti Flex Mini network switches. I have them installed in walls and under the table. The Flex Mini has a very rubbery bottom patch which keeps it in place without any additional supports over the front or back.

This wall mount can easily be installed very close to cabinets or other obstacles as the switch can be installed from front by just pushing it into place.

Tested with PLA and PETG. Both works very nicely.

For best results should be printed as it would be installed into the wall. Requires good adhesion to the printing bed because of the low contact area.