TTGO T-Camera video doorbell

--- SHOULD BE CONSIDERED AS A WORK IN PROGRESS ---

Made this 3D-printed housing for a TTGO T-Camera ESP32 module to work as a video doorbell for use in Home Assistant. Also fits a 12 mm illuminated push button, that can be wired to the module's button (as it's own button is small and not good).

This design is not completed and should be remixed/further developed. Even though one can look at this as a proof of concept, as the current design has been in use since the summer. It has even survived the Norwegian winter thus far!

The backside is angled so that it can be mounted on the side of the door, while facing the person standing in front. The backside has a whole for cables (I used an Ethernet cable) so that the cable can be threaded through the backside without being seen.

For more details, check out the Github repo

Category: Electronics