1 lb. solder holder (Remix of Solder Holder by Leon@Matthews)

I remixed the solder holder by Leon@Matthews. I like his design but needed a slightly larger capacity and different size spindle for the spool.

The spacers, front pass-through for the solder and spindle are 58mm wide to accomodate the 1 lb. solder spool.

The spindle was changed in diameter to Ø19mm to fit the solder spool as well.

I used the original sides from his design and I like the honeycomb design.

The printing profile I used was .320mm layer height with a .6mm nozzle for fast printing. It would look better with a smaller layer height and a .4mm nozzle.

The remixed parts also use a M3 heat-set threaded insert in each end of the spacers and the solder pass-through. 8 total inserts and 10mm long M3 screws needed to assemble.