Remix v1 of Arduino Tricorder with Easy Print Faces

This was my first go at making a easier to print tricorder to match Lambtor's Arduino Tricorder project.  A more complete version is here: https://www.printables.com/model/225964-printability-remix-of-arduino-tricorder

--------------

No stl files here, I used PrusaSlicer to divide Lambtor's tricoder face into easy to print sections.  Print using the 3mf file.

• Face and door cover are separated into multiple parts.  Held together by temporary tape, and eventually permanently glued into the body.
• Sticker groves are removed so the part could be printed face down.
• Hinges are attached into friction tight slots.  If you break one, you don't have to reprint the whole cover!

Other Notes:

In my photo, you can see that the top plate doesn't mate with the body fully.  That edge was too thin for my 0.2mm layer height to print.  To correct, make sure your print has smaller layer lines.  I plan to add light blocking tape or glue to mine.

The hinge pegs are friction tight.  They snap in HARD.