Slightly Fancier Tardis Dice Tower Base

This model includes a couple of tweaks from the excellent original. My d20s were jumping the rails so I made them about half-again as tall. I also felt it looked just a bit plain next to the Tardis model, so I added a subtle brick pattern. This also had the effect, unintended but not unwanted, of slowing down the dice and helping to keep them in the pen.

Printing Instructions

What you see in the photos above were printed on a Prusa MK3S+, using a 0.4 nozzle and 0.2mm layer height. The filament is Polymaker gray PLA.

No supports are needed