HP f210 Dashcam Mount for Vertical Rear Window

A mount to adapt your HP f210 dashcam to position it in the rear window of a ute/pick-up truck or van.

Requires modification to the mount that comes with your dashcam.

I have printed the parts in PETG and they have survived a summer in Brisbane, Australia without issue!

Additional Parts 

1x M4x10 screw

1x M5 nut

3x Suction cups with an 8mm stalk

Assembly (Refer to photo montage)

1. Gather all parts required.
2. Cut your mount as shown and drill and tap an M4 hole approx. 10mm deep.
3. Fit the mount to your dashcam.
4. Find your 3D printed parts.
5. Insert the M5 nut into the recess in the small bracket.
6. Use the screw knob that came with your dashcam to fit the bracket to the main mount.
7. Press in the suction cups on the front face as shown.
8. Make sure they are well seated.
9. Fit the assembly to the dashcam as shown in the first large photo.