XT-60 Female Flat Panel Enclosure Mount for Amass Connectors IMPROVED

I remixed "Amass XT60 enclosure mount" to fit better with the following improvements

• Made the hole for the front mount and front half of the connector 0.5mm larger in each dimension for easier fitting of male piece when connecting
• First 3mm of connector is larger so the Amass female connector fits in far enough that the male end can fully press in
• Doubled the height of the two side hex nut holders and made them a little smaller so the nuts friction fit in perfectly

One of the files is a .3mf file I exported from PrusaSlicer, you can just load that in and tweak settings as you want. I printed with a "support enforcer" under the overhang but nowhere else, so that support only prints there. I don't bother removing the supports because it's just 2 layers of it and screwing in the nut breaks free of it easily enough.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill: