Octopi and Cam rack for Ender 3 S1 Pro

UPDATE:

• add MyPiHolderMount v3.stl, which will enable to use Articulating Raspberry Pi Camera Mount for Prusa MK3 and MK2 by Sneaks for mounting the raspberry pi camera
• add rpCaseSupport v1.stl, which can be used to support the raspberry pi itself

======

This is a rack for hosting raspberry pi 4 installed with Octoprint as well as the camera holder.

The pi rack is open designed to allow max air flow.

For camera holder you will need to print number of arms large/medium/small to suite your need.

• At least there should be one A type arm.
• Usually it will be one large B, one medium B, and one medium A.
• Or you can print more arms to suit your need.

Camera case is designed for the raspberry pi camera, but should be ok to most compatible camera if do not use the front cover.

How to install

• loose the right corner screws in the base of Ender 3 S1 pro, push the my mount print into and then put screws back
• after that the pi case can be installed to the left with the dove tail joint
• cam holder is easy as seen in picture, push in

This design has borrowed lots of design from following projects

• Pi case: https://www.thingiverse.com/thing:1226828
• Pi cam arm: https://www.thingiverse.com/thing:4408079