Crokinole wall hang hooks

I designed a system to hang my Ferti Crokinole on the wall.

It consists on 2 bottom hooks and 1 top hook.

You have to tilt the board to introduce the crokinole slot in the top hook, rotate it to make it vertical and slide it down to the bottom hooks. Then just slide the board to the front.

I wanted to print the hooks in PETG but the tests with PLA where strong enough.

I printed them over one side at 0.3 layer height, 5 walls (sides, top and bottom), 20% giroid infill.

I designed a slotted top hook too if you need to fine-tune the top hook position.