Status Plaques

I work from home and get a lot of “Hey are you busy?” questions. The family often doesn't know I'm in a meeting until they get caught on camera. There are other times when interruptions are very inconvenient (like when I'm writing)

I made these little plaques to stand on my desk and let my family know - from a distance - if I cannot be disturbed.

My nephew liked them so much he asked for two for himself (gaming and discord call) so I've included them here as well. 

Note: 

• The headphones on the discord plaque may need support material based on your cooling and printer.  
• I have a single extruder on both of my machines and have printed multicolor through judicious use of slicing software. YMMV
• I have confirmed these files will work on SuperSlicer and on Cura but have not tested any other slicers. 
  • Cura tells me it's not watertight but prints fine. SuperSlicer tells me it is manifold so I'm not sure what the issue is. 

Thanks for stopping by. Hope you like them. Feedback welcome.  

Updates:

• 6/3/2022: resized the holder as it was too large for the plates. changed from 115mm to 112