LED Power Supply Mount for 2060 Extrusion

This is a LED Power Supply mount for 2060 aluminum extrusion. I designed this part to be used with OpenBuilds Aluminum Extrusion

I built a workbench out of aluminum extrusion and I needed a mount to hold a power supply for my LED lights. I made this in 2 parts, the small mount bolts to the power supply and rests in the track of the extrusion with a lip. The large mount bolts to the power supply and then also bolts to the aluminum extrusion with 2 x M5 8mm bolts and 2 x tee nuts.

On the large mount, I've added an opening for an IEC power inlet and a holder for a 3-way Wago connecter. The Wago connecter is necessary if you plan on using a switch to control the LEDs. I've also added an opening beside the Wago housing for wires to exit into the extrusion track to keep things tidy.

The power supply requires 4 x M3 12mm bolts to attach to the mounts. The IEC Inlet require 2 x M3 12mm bolts and 2 x M3 nuts.

This was my first time using a Voronoi editor in my designs. My main objective was to create better airflow for the power supply and to give the mount a bit of 'spice'.

BOM LED Power Supply IEC Inlet Wago Connectors M3 + M5 Bolt Kit M5 Tee Nuts

I printed the parts out of Easy PC CPE. 0.4 nozzle and 0.2 layer height. I used supports only for the small mount. The voronoi pattern came out fine on both parts without.

This pairs well with my Rocker Switch and 2020 Rail Clips

Print Settings

Supports:

Doesn't Matter

Resolution: 

.2

Infill:

15%

Filament:

Filaments.ca Easy-PC CPE

Black

Category: Electronics